Monthly Archives: January 2017

High Gloss PU

This question was asked by
Robert Mckelvie

Hi, just wondering if your High Gloss PU is safe to use on high gloss white laminate tiles?

The High gloss PU should be ok to use, but, it is not sometime I have ever tested it on so I cannot say with 100% certainty that it will be ok. You would need to test it before applying to the whole area.

Drew Palin

I am looking for the correct colour concrete stain, do you have sample sizes?

This question was asked by
Jason Winslow

Hi

I’m looking to enhance an area of concrete and was wondering if you might be able to do smaller ‘tester’ samples at all? At the moment the concrete has just been laid and is it’s natural colour. We think we\’d like it to be more of a slate / charcoal sort of colour but not sure, so we\’d like to trial a couple of tiny areas first.

We also like the idea of stencilling, and considering a grey finish with lighter grey / white-ish pattern.

What product(s) would you recommend, and can you do little samples?

Kind regards,

Jason

Firstly as the concrete has just been laid you will need to wait a minimum of 30 days to allow the concrete to cure before applying the stains to the surface.

you will then need to acid wash the surface to remove any dust or dirt and to profile the concrete to allow the stain to penetrate properly.

I would then suggest using the Solid Colour Stain to the surface, this will give you an opaque colour in whichever colour you choose.

Then if you are looking to use any further colours you will need to use the Smartcolour stain over the Solid colour.

Both these colours are available to by in a 4oz tester size.

http://www.adsealcolours.co.uk/Solid-Colour-Stain.html

http://www.adsealcolours.co.uk/Smart-Colour-Stain.html

http://www.adsealcolours.co.uk/Eco-Acid-profiler.html
Drew Palin

How do I clean my brushes after sealant application?

This question was asked by
Neville Kitching

Can I use water to clean brushes after application on a kitchen floor. Or is there a specific brush cleaner?

Personally I just use inexpensive brushes and dispose of after use.

To clean any equipment after using our solvent based sealer you will need to use our Solvent.

http://www.adseal.info/adseal-solvent-cleaner-and-reemulsifier.html
Drew Palin