Graf-X Graffiti Cleaner

Fast-Acting Graffiti & Paint Remover

Coverage & Packaging

Technical Data Sheets

Application Instructions

Safety Data Sheets

Uses & Applications

Graf-X Cleaner safely cleans graffiti from a variety of surfaces, including stucco, concrete, natural stone, rock, tile, fiberglass, aluminum, alloys, stainless steel, plastic, plexiglass, brick and other masonry surfaces. Commonly used to clean residential and commercial properites, as well as municipal walls, architectural fixtures, vehicles and street signs.

Preparation

Test surfaces before using; apply a small amount to an inconspicuous area. If surface marks, dulls, discolors, fades then DO NOT USE. Not recommended for used on varnished surfaces, non-colorfast materials or woodwork when not protected with Graf-X WB.

Directions

For Use on Porous Surfaces (e.g. Brick, Concrete, Stucco, Etc.):
Spray affected area thoroughly with standard pump sprayer equipment. Wait 3–5 minutes. Use a firm brush to loosen dried paint. Use hose to rinse off and wipe with a clean towel. For best results on problem areas, use a high-pressure spray washer. 

For Use on Hard Surfaces (e.g. Street Signs, Tile, Etc.):
Spray affected area thoroughly. Wait approximately 60 seconds. Wipe with clean, disposable towel or cloth. Repeat if necessary. 

Maintenance

Apply additional coats of Graf-X WB as needed. Use NewLook Graf-X Cleaner to remove graffiti and paint from either Graf-X WB or unsealed surfaces. Clean tools and equipment with xylene or mineral spirits.