The NewLook Applicator Brush is an industrial-grade, flag-tipped brush used to install NewLook’s concrete colour stains. The soft, dense bristles make it the most effective tool for installing the ORIGINAL Solid Color Stain™, CoolStain™ PRO, TiqueWash™, and the only one Adseal & Newlook recommends or warrants.
Each brush has a standard size female thread for male threaded broom handles (not included).
We strongly recommends using these specific brushes and cannot guarantee (or warrant) installation results if the stains are applied without them.
Available in 100mm (4”) round, 200mm (8”), 250mm (10”), 450mm (18”) and 600mm (24”) long sizes
I would like to colour a newly laid 30 square metre concrete drive with Smart colour (Licorice). Please could you advise the amounts of prep material, colour and sealer (satin finish) required for this. Many thanks
As the concrete is new you will need to leave it a minimum of 30days before trying to stain to let the concrete cure.Before staining you will need to acid wash the surface to remove any loose dusty surface from the concrete using the Eco acid If you are looking to apply a single solid colour to the concrete I would recommend using the Solid colour stain (medium grey) you will need 1 x 32oz kit to do your area. The solid colour stain will be much quicker, easier and cheaper than the smartcolour (you would need at least 3 x 32oz bottles to get a solid uniform colour). Then finally to seal I would suggest the WB25. I have listed all the relevant products below, I would highly recommend watching the installation videos before you start the job. http://www.adsealcolours.co.uk/Eco-Acid-profiler.html http://www.adsealcolours.co.uk/Solid-Colour-Stain.html http://www.adsealcolours.co.uk/WB-25-eco-friendly-satin-concrete-sealer.html http://www.adsealcolours.co.uk/Application-Brushes.html Drew Palin